beautypg.com

To configure the pef global controls, Configuring the event filter tables – Sun Microsystems Sun Fire X4150 User Manual

Page 98

background image

82

Sun Fire X4150 Server Embedded Lights Out Manager Administration Guide • September 2007

To Configure the PEF Global Controls

1. To configure the PEF global controls, you must first enable global control by

entering the following commands:

–> cd /SP/AgentInfo/PEF

/SP/AgentInfo/PEF –> set PEFGlobalCtrl=enable

After enabling global control, you can enable global control for specific actions.

2. To enable global PEF control for a specific action, enter the following

commands for each PEFActionGlobalCtrl that you want to enable:

Note –

This example shows how to enable the power reset PEF global action:

–> cd /SP/AgentInfo/PEF

/SP/AgentInfo/PEF –> set PEFActionGlobalCtrlPowerReset=enable

Configuring the Event Filter Tables

The event filter table is where you designate the specific altert-triggered actions. You
can configure up to six event filter tables. These targets, properties, and values are
valid for setting the PEF:

Target

Property

/SP/AgentInfo/PEF/EventFilterTable[1-6]/status

enable|disable

/SP/AgentInfo/PEF/EventFilterTable[1-6]/sensortype

All, Memory, Processor,
Temperature, Voltage,
Fan

/SP/AgentInfo/PEF/EventFilterTable[1-6]/powercrtl

enable|disable

/SP/AgentInfo/PEF/EventFilterTable[1-6]/diagnosticinterrupt

enable|disable

/SP/AgentInfo/PEF/EventFilterTable[1-6]/sendalert

enable|disable

/SP/AgentInfo/PEF/EventFilterTable[1-6]/sendmail

enable|disable