Sun Microsystems Sun Fire X4150 - Manual (Page 87)

Chapter 7 Using the Command-Line Interface 71
Command Verbs
TABLE 7-1 describes the CLI command verbs.
Options
The CLI supports the following options. Not all options are supported for all
commands. See a specific command section for the options that are valid with that
command. The -help and -examine options can be used with any command.
TABLE 7-1 CLI Command Verbs
Command Description
cd Navigates the object namespace.
create Sets up an object in the namespace.
delete Removes an object from the namespace.
exit Terminates a session to the CLI.
help Displays Help information about commands and targets.
losd
reset Resets the target’s state.
set Sets target properties to the specified value.
show Displays information about targets and properties.
start Starts the target.
stop Stops the target.
version Displays the version of ELOM firmware that is running.
TABLE 7-2 CLI Options
Option Long Form Short Form Description
-default Causes the verb to perform only its default functions.
-destination Specifies the destination for data.
-display -d Shows the data you want to display.
-examine -x Examines the command but does not execute it.
-force -f Causes an immediate action instead of an orderly
shutdown.
-help -h Displays Help information.