Sun Microsystems Sun Fire X4150 - Manual (Page 48)

32 Sun Fire X4150 Server Embedded Lights Out Manager Administration Guide • September 2007
FIGURE 4-2 The Platform Event Filter Screen
2. In the The Platform Event Filter section click the Enable PEF radio button.
To configure/create a filter, you must first enable PEF.
3. Type the address of the trap receiver in the Trap Receiver Destination Address
section.
4. Enable all actions that you would like to be available for your filters by
selecting the appropriate check box in the PEF Action Global Control section.
The actions are:
■
Enable Power Off Action
■
Enable Power Cycle Action
■ Enable Power Reset Action
■ Enable Diagnostic Interrupt Action
■ Enable Send Alert Action
■ Enable Send Mail Action
5. Select the sensor group for which you would like to filter alerts from the drop-
down list in the Event Filter Configuration.
The options are:
■
ffh - All sensors