Sun Microsystems Sun Fire X4150 - Manual (Page 90)

74 Sun Fire X4150 Server Embedded Lights Out Manager Administration Guide • September 2007
show /SYS/CPU/CPU0
For more information about sensors, including how to view them using a web
browser, see
“Monitoring the System Sensors” on page 19 .
Managing ELOM Network Settings
You can display or configure the ELOM network settings from the CLI.
▼ To Display Network Settings
Enter the following command to display or set network settings:
show /SP/network (This will display all network settings.)
▼ To Configure Network Settings
Use the set command to change properties and values for network settings.
Note – Ensure that the same IP address is always assigned to an ELOM by either
assigning a static IP address to your ELOM after initial setup, or configuring your
DHCP server to always assign the same IP address to an ELOM. This enables the
ELOM to be easily located on the network.