Sun Microsystems Sun Fire X4150 - Manual (Page 91)

Chapter 7 Using the Command-Line Interface 75
Targets, Properties, and Values
These targets, properties, and values are valid for ELOM network settings.
Examples
To change the IP address for the ELOM, Enter:
Note – Changing the IP address will disconnect your active session if you are
connected to the ELOM via a network.
Syntax
set /SP/network IPAddress= n.n.n.n
set /SP/network Gateway= n.n.n.n
set /SP/network DNS= n.n.n.n
set /SP/network IPSource=[static|dhcp]
Managing Local User Accounts With the
CLI
This section describes how to add, modify, and delete user accounts using the CLI.
The ELOM supports up to 10 user accounts. One of those, root, is set by default and
cannot be removed. Therefore, you can configure 9 additional accounts.
Each user account consists of a user name, a password, and a permission.
The permisisons include:
TABLE 7-3
Target Property Value Default
/SP/network IpAddress
IPSource
Gateway
Netmask
ipaddress|none
static/dhcp
ipaddress|none
ipdotteddecimal
192.168. last 2 digits of MAC address
enabled (only if DHCP not found)
dhcp
None
255.255.255.0