Sun Microsystems Sun Fire X4150 - Manual (Page 79)

Chapter 6 Using IPMI 63
ipmitool -H ipaddress of the SP -U root -P password sel list
Depending on where IPMItool is installed from, the -P option might be missing. In
such a case, do not type the -P in the previous command, and enter the password
when prompted.
Supported IPMI 2.0 Commands
TABLE 6-2 lists the supported IPMI 2.0 commands.
For details on individual commands, see the IPMI Intelligent Platform Management
Interface Design Specification, v2.0. A copy is available at:
http://www.intel.com/design/servers/ipmi/spec.htm
TABLE 6-1 Supported IPMI 2.0 Commands
Commands Description
raw Send a RAW IPMI request and print response
i2c Send an I2C Master Write-Read command and print response
lan Configure LAN channels
chassis Get chassis status and set power state
power Shortcut to chassis power commands
event Send predefined events to MC
mc Management Controller status and global enables
sdr Print Sensor Data Repository entries and readings
sensor Print detailed sensor information
fru Print built-in FRU and scan SDR for FRU locators
sel Print system event log (SEL)
pef Configure platform event filtering (PEF)
sol Configure and connect IPMIv2.0 Serial-over-LAN
tsol Configure and connect with Tyan IPMIv1.5 Serial-over-LAN
isol Configure IPMIv1.5 Serial-over-LAN
user Configure Management Controller users
channel Configure Management Controller channels
session Print session information