SMC Networks SMC EZ 10/100/1000 SMCGS8P-Smart - Manual (Page 328)

C
OMMAND
L
INE
I
NTERFACE
3-160
Priority Commands
The commands described in this section allow you to specify
which data packets have greater precedence when traffic is
buffered in the switch due to congestion. This switch supports CoS
with four priority queues for each port. Data packets in a port’s
high-priority queue will be transmitted before those in the
lower-priority queues. You can set the default priority for each
interface, the relative weight of each queue, and the mapping of
frame priority tags to the switch’s priority queues.
Command Function Mode Page
Layer 2 Priority Commands
switchport priority
default Sets a port priority for incoming
untagged frames IC 3-161
queue bandwidth Assigns round-robin weights to the
priority queues GC 3-162
queue cos map Assigns class of service values to the
priority queues IC 3-163
show queue
bandwidth Shows round-robin weights assigned
to the priority queues PE 3-165
show queue
cos-map Shows the class of service map PE 3-166
show interfaces
switchport Displays the administrative and
operational status of an interface PE 3-106
Layer 3 and 4 Priority Commands
map ip precedence Enables IP precedence class of service
mapping
GC 3-166
map ip precedence Maps IP precedence value to a class of
service
IC 3-167
map ip dscp Enables IP DSCP class of service
mapping GC 3-169
map ip dscp Maps IP DSCP value to a class of
service IC 3-170
b_mgmt.book Page 160 Tuesday, July 8, 2003 5:24 PM