SMC Networks SMC EZ 10/100/1000 SMCGS8P-Smart - Manual (Page 303)

VLAN C
OMMANDS
3-135
Example
The following shows how to set the configuration mode to port 1,
and then set the switchport mode to hybrid:
Related Commands
switchport acceptable-frame-types
switchport acceptable-frame-types
Use this command to configure the acceptable frame types for a
port. Use the no form to restore the default.
Syntax
switchport acceptable-frame-types {all | tagged}
no switchport acceptable-frame-types
• all - The port passes all frames, tagged or untagged.
• tagged - The port only passes tagged frames.
Default Setting
All frame types
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
When set to receive all frame types, any received frames that
are untagged are assigned to the default VLAN.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport mode hybrid
Console(config-if)#
b_mgmt.book Page 135 Tuesday, July 8, 2003 5:24 PM