SMC Networks SMC EZ 10/100/1000 SMCGS8P-Smart - Manual (Page 237)

SNMP C
OMMANDS
3-69
snmp-server enable traps
Use this command to enable this device to send Simple Network
Management Protocol traps (SNMP notifications). Use the no form
to disable SNMP notifications.
Syntax
snmp-server enable traps [authentication | link-up-down]
no snmp-server enable traps [authentication |
link-up-down]
• authentication - Keyword to issue authentication failure
traps.
• link-up-down - Keyword to issue link-up or link-down
traps.
Default Setting
Issue authentication and link-up-down traps.
Command Mode
Global Configuration
Command Usage
• If you do not enter an snmp-server enable traps command,
no notifications controlled by this command are sent. In order
to configure this device to send SNMP notifications, you must
enter at least one snmp-server enable traps command. If you
enter the command with no keywords, all notification types are
enabled. If you enter the command with a keyword, only the
notification type related to that keyword is enabled.
• The snmp-server enable traps command is used in
conjunction with the snmp-server host command. Use the
snmp-server host command to specify which host or hosts
receive SNMP notifications. In order to send notifications, you
must configure at least one snmp-server host command.
b_mgmt.book Page 69 Tuesday, July 8, 2003 5:24 PM