SMC Networks SMC EZ 10/100/1000 SMCGS8P-Smart - Manual (Page 205)

S
YSTEM
M
ANAGEMENT
C
OMMANDS
3-37
Command Usage
• You cannot configure the HTTP and HTTPS servers to use the
same port.
• If you change the HTTPS port number, clients attempting to
connect to the HTTPS server must specify the port number in
the URL, in this format:
https://device:port_number
Example
Related Commands
ip http secure-server (3-35)
ip ssh
Use this command to configure authentication control parameters
for the Secure Shell (SSH) server on this switch. Use the no form
to restore the default settings.
Syntax
ip ssh {[timeout seconds] | [authentication-retries count]}
no ip ssh {[timeout] | [authentication-retries]}
• seconds – The timeout for client response during SSH
negotiation. (Range: 1-120)
• count – The number of authentication attempts permitted
after which the interface is reset. (Range: 1-5)
Default Setting
timeout: 120 seconds
count: 3
Command Mode
Global Configuration
Console(config)#ip http secure-port 1000
Console(config)#
b_mgmt.book Page 37 Tuesday, July 8, 2003 5:24 PM