SMC Networks SMC EZ 10/100/1000 SMCGS8P-Smart - Manual (Page 286)

C
OMMAND
L
INE
I
NTERFACE
3-118
spanning-tree max-age
Use this command to configure the Spanning Tree bridge
maximum age globally for this switch. Use the no form to restore
the default.
Syntax
spanning-tree max-age seconds
no spanning-tree max-age
seconds - Time in seconds. (Range: 6-40 seconds)
The minimum value is the higher of 6 or
[2 x (hello-time + 1)].
The maximum value is the lower of 40 or
[2 x (forward-time - 1)].
Default Setting
20 seconds
Command Mode
Global Configuration
Command Usage
This command sets the maximum time (in seconds) a device
can wait without receiving a configuration message before
attempting to reconfigure. All device ports (except for
designated ports) should receive configuration messages at
regular intervals. Any port that ages out STP information
(provided in the last configuration message) becomes the
designated port for the attached LAN. If it is a root port, a new
root port is selected from among the device ports attached to
the network.
Example
Console(config)#spanning-tree max-age 40
Console(config)#
b_mgmt.book Page 118 Tuesday, July 8, 2003 5:24 PM