SMC Networks SMC EZ 10/100/1000 SMCGS8P-Smart - Manual (Page 248)

C
OMMAND
L
INE
I
NTERFACE
3-80
Line Commands
You can access the onboard configuration program by attaching a
VT100 compatible device to the server’s serial port. These
commands are used to set communication parameters for the serial
port or a virtual terminal. Note that Telnet is considered a virtual
terminal connection, and the only commands that apply to Telnet
include exec-timeout and password-thresh.
Command Function Mode Page
line Identifies a specific line for configuration
and starts the line configuration mode GC 3-81
login Enables password checking at login LC 3-82
password Specifies a password on a line LC 3-83
exec-timeout Sets the interval that the command
interpreter waits until user input is
detected LC 3-84
password-
thresh Sets the password intrusion threshold,
which limits the number of failed logon
attempts LC 3-85
silent-time Sets the amount of time the management
console is inaccessible after the number of
unsuccessful logon attempts exceeds the
threshold set by the password-thresh
command LC 3-86
databits Sets the number of data bits per character
that are interpreted and generated by
hardware LC 3-87
parity Defines the generation of a parity bit LC 3-88
speed Sets the terminal baud rate LC 3-89
stopbits Sets the number of the stop bits
transmitted per byte LC 3-90
show line Displays a terminal line's parameters NE,
PE 3-90
b_mgmt.book Page 80 Tuesday, July 8, 2003 5:24 PM