SMC Networks SMC EZ 10/100/1000 SMCGS8P-Smart - Manual (Page 299)

VLAN C
OMMANDS
3-131
vlan database
Use this command to enter VLAN database mode. All commands in
this mode will take effect immediately.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Use the VLAN database command mode to add, change, and
delete VLANs. After finishing configuration changes, you can
display the VLAN settings by entering the show vlan
command.
• Use the interface vlan command mode to define the port
membership mode and add or remove ports from a VLAN. The
results of these commands are written to the
running-configuration file, and you can display this file by
entering the show running-config command.
Example
Display VLAN Information
show vlan Shows VLAN information NE,
PE 3-140
show interfaces
status vlan Displays status for the specified
VLAN interface NE,
PE 3-103
show interfaces
switchport Displays the administrative and
operational status of an interface NE,
PE 3-106
Console(config)#vlan database
Console(config-vlan)#
Command Function Mode Page
b_mgmt.book Page 131 Tuesday, July 8, 2003 5:24 PM