SMC Networks SMC EZ 10/100/1000 SMCGS8P-Smart - Manual (Page 183)

G
ENERAL
C
OMMANDS
3-15
Command Mode
Normal Exec
Command Usage
• “super” is the default password required to change the
command mode from Normal Exec to Privileged Exec. (To set
this password, see the enable password command on page
3-31.)
• The “#” character is appended to the end of the prompt to
indicate that the system is in privileged access mode.
• You only need to use Level 15. Setting the password for Level
0 has no effect.
• You cannot set a null password with the enable password
command. You will have to enter a password to access the
Privileged Exec mode.
Example
Related Commands
disable (3-15)
enable password (3-31)
disable
Use this command to return to Normal Exec mode from privileged
mode. In normal access mode, you can only display basic
information on the switch's configuration or Ethernet statistics. To
gain access to all commands, you must use the privileged mode.
See “Understanding Command Modes” on page 3-7.
Default Setting
None
Console#enable
Console#
b_mgmt.book Page 15 Tuesday, July 8, 2003 5:24 PM