SMC Networks SMC EZ 10/100/1000 SMCGS8P-Smart - Manual (Page 276)

C
OMMAND
L
INE
I
NTERFACE
3-108
mac-address-table static
Use this command to map a static address to a port in a VLAN. Use
the no form to remove an address.
Syntax
mac-address-table static mac-address interface interface
vlan vlan-id [action]
no mac-address-table static mac-address vlan vlan-id
• mac-address - MAC address.
• interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-4)
• vlan-id - VLAN ID (Range: 1-4094)
• action -
• delete-on-reset - Assignment lasts until switch is reset.
• permanent - Assignment is permanent.
Default Setting
No static addresses are defined. The default mode is
permanent.
clear
mac-address-table
dynamic Removes any learned entries from the
forwarding database PE 3-111
mac-address-table
aging-time Sets the aging time of the address table GC 3-111
show
mac-address-table
aging-time Showsthe aging time for the address
table PE 3-112
Command Function Mode Page
b_mgmt.book Page 108 Tuesday, July 8, 2003 5:24 PM