SMC Networks SMC EZ 10/100/1000 SMCGS8P-Smart - Manual (Page 302)

C
OMMAND
L
INE
I
NTERFACE
3-134
Example
The following example shows how to set the interface
configuration mode to VLAN 1, and then assign an IP address to
the VLAN:
Related Commands
show vlan (3-140)
switchport mode
Use this command to configure the VLAN membership mode for a
port. Use the no form to restore the default.
Syntax
switchport mode {trunk | hybrid}
no switchport mode
• trunk - Specifies a port as an end-point for a VLAN trunk. A
trunk is a direct link between two switches, so the port
transmits tagged frames that identify the source VLAN.
However, note that frames belonging to the port’s default
VLAN (i.e., associated with the PVID) are sent untagged.
• hybrid - Specifies a hybrid VLAN interface. The port may
transmit tagged or untagged frames.
Default Setting
All ports are in hybrid mode with the PVID set to VLAN 1.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#
b_mgmt.book Page 134 Tuesday, July 8, 2003 5:24 PM