SMC Networks SMC EZ 10/100/1000 SMCGS8P-Smart - Manual (Page 257)

L
INE
C
OMMANDS
3-89
Command Usage
Communication protocols provided by devices such as
terminals and modems often require a specific parity bit setting.
Example
To specify no parity, enter this command:
speed
Use this command to set the terminal line's baud rate. This
command sets both the transmit (to terminal) and receive (from
terminal) speeds. Use the no form to restore the default setting.
Syntax
speed bps
no speed
bps - Baud rate in bits per second.
(Options: 9600, 57600, 38400, 19200, 115200 bps)
Default Setting
9600 bps
Command Mode
Line Configuration
Command Usage
Set the speed to match the baud rate of the device connected
to the serial port. Some baud rates available on devices
connected to the port might not be supported. The system
indicates if the speed you selected is not supported.
Console(config-line)#parity none
Console(config-line)#
b_mgmt.book Page 89 Tuesday, July 8, 2003 5:24 PM