Siemens CP 1515 - Manual (Page 228)

5HVWRULQJ D %DFNXS &RQILJXUDWLRQ
228 Industrial Ethernet Wireless LAN RLM Manager, CP 1515 Manager
C79000-G8976-C171-01
5HVWRULQJ D %DFNXS &RQILJXUDWLRQ
To restore previously saved back-up configuration files to your Access Point
RLM proceed as follows:
1. Start the RLM Manager program.
2. Select the Radio Link Module you want to upload the configuration file
to.
3. From the Access Point RLM menu select
8SORDG &RQILJ )LOH
.
4. Select the configuration file you want to upload, and click
2SHQ
.
5. When prompted to confirm the upload, verify whether the pop-up
message reflects the correct IP address.
• When the IP address value is correct, click to proceed. The
Access Point RLM will now reset automatically.
• If the IP address is not correct, click
1R
to return to cancel the
upload procedure
The new parameter settings will now be loaded into the FlashROM of the
Radio Link Module. This means that the parameters will remain intact
whenever the RLM is reset or switched off and on again. To change the
parameters again, simply repeat the procedure as described in this section
to reconfigure your RLMs.