Siemens CP 1515 - Manual (Page 101)

8VLQJ WKH 5/0 0DQDJHU
Industrial Ethernet Wireless LAN RLM Manager, CP 1515 Manager
C79000-G8976-C171-01
101
6\VWHP ,QIRUPDWLRQ
The system information does not provide on-line statistics, but is primarily
used to verify the version level of the embedded software that is loaded into
the Access Point RLM.
To display the system information for the RLM, you must first connect to the
target RLM (see
Connecting to Access Points RLMs (page 99) ).
Select the
6\VWHP
tab to view the system information.
• The fields
1DPH
,
/RFDWLRQ
and
&RQWDFW
represent the values that have
been entered in the corresponding fields of the
6103
tab in the edit
mode when the Access Point RLM was configured.
If you would like to change these names, please consult the section
about configuring SNMP parameters as described in
SNMP Parameters
(page 211) .
• The
8S 7LPH
field displays the time interval measured from the last
time the Radio Link Module was reset. If the up time is lower than
expected, the RLM may have been reset manually or rebooted
automatically.
• The fields
6HUYLFHV
and
2EMHFW ,'
do not display relevant information
to end-users. You will need these values and the contents of the
'HVFULSWLRQ
field only when contacting Technical Support to report a
problem.
Providing this information to your Technical Support representative will
help to determine the cause of the problem.
To do so, you can either: