Siemens CP 1515 - Manual (Page 222)

&RQILJXULQJ /DUJH 1HWZRUNV
222 Industrial Ethernet Wireless LAN RLM Manager, CP 1515 Manager
C79000-G8976-C171-01
• Use the “Access Point Configuration Record” to assign one IP address to
each of your RLMs.
• Record the intended system location of each Radio Link Module on the
“Access Point Configuration Record”
.
&UHDWLQJ D 7HPSODWH )LOH
1. To create a template file, configure the first Access Point RLM as
described earlier under
Configuring Infrastructure Networks (page 58) .
2. Save the configuration of this Radio Link Module to disk as described in
Step 4 - Create a Back-up of the Configuration (page 66) .
3. Create a copy of the back-up file with the name “common.cnf” or any
other name that will allow you to easily recognize the file as the actual
template file that we will use as the basis to configure the other RLMs in
your network.
&$87,21 !
'R QRW VWDUW XVLQJ \RXU RULJLQDO EDFNXS ILOH DV WHPSODWH ILOH
$Q\ FKDQJHV \RX PDNH WR WKH ILOH PLJKW LPSDLU \RXU DELOLW\
WR IXOO\ UHVWRUH WKH RULJLQDO FRQILJXUDWLRQ RI \RXU ILUVW 5/0
LI WKH XQLW JRHV RXW RI VHUYLFH $OZD\V VWRUH EDFNXS FRSLHV
RQ D VHSDUDWH GLVN DQGRU ORFDWLRQ
&RQILJXULQJ RWKHU 5DGLR /LQN 0RGXOHV
Having created the template file, we can now start (re-)configuring the other
RLMs in batch-mode. For each Access Point RLM, the procedure will be as
follows: