Siemens CP 1515 User Manual
Page 210
$GYDQFHG 3DUDPHWHUV
210
Industrial Ethernet Wireless LAN RLM Manager, CP 1515 Manager
C79000-G8976-C171-01
the field
2EWDLQ DQ ,3 DGGUHVV IURP '+&3 VHUYHU
on the
$FFHVV 3RLQW
,3
tab.
For more information about DHCP refer to
6XEQHW 0DVN
The field
$FFHVV 3RLQW 6XEQHW 0DVN
is a common parameter and must
be the same for ALL network devices within your IP subnet.
You can use either the default value (255.255.0.0) or change the subnet
mask to a value that applies in your network.
If
2EWDLQ DQ ,3 DGGUHVV IURP '+&3 VHUYHU
is enabled, the subnet is also
automatically entered.
'HIDXOW 5RXWHU
The field
'HIDXOW 5RXWHU ,3
is an optional field that is relevant when you
intend to use the Radio Link Module support for TRAP messages (see also
).
You can use the Default Router IP field to identify the IP address of the
router which the RLM will use to find the Trap Host IP Address (identified in
the SNMP Parameters).
The default router and the trap host IP address described later in this chapter
are only used for TRAP messages generated by the Access Point RLM upon
a reset, modification of the configuration, or forced reload procedure.
If the value of the field
'HIDXOW 5RXWHU ,3
is set to 0.0.0.0 (default), then no
TRAP messages are initiated by this Radio Link Module.