Muratec PLAIN-PAPER DIGITAL FAX/COPIER/PRINTER/SCANNER MFX-1330 - Manual (Page 70)

4.6 S
ENDING FAXES
Real time transmission (Non memory transmission)
Your machine simply dials the other fax and when it makes contact, your machine feeds
the document through, scanning and transmitting it as it goes.
• With real time transmission, you can watch each page as it is scanned and sent.
To perform the real time transmission:
1
Switch to the Fax mode by pressing
COPY  FAX  SCAN
.
2
Place the document on the ADF.
NOTE: • The document glass cannot be used for real time transmission.
• The document glass is available only for MFX-1330 model.
3
Obtain a dial tone, either:
• Press
ADVANCED FUNCTIONS
repeatedly until “Monitor” appears, then press
ENTER
.
– or –
Press the soft key in which “Monitor” is assigned.
–or–
• Lift the handset if you have connected an external telephone to your machine.
In either case, the machine shows:
** Tel Mode **
_
– or –
Press
ADVANCED FUNCTIONS
repeatedly until “Memory Tx” appears and press
ENTER
.
Then select “Off” and press
ENTER
to turn off the memory transmission.
– or –
If you assigned “Memory Tx” to the soft key (page 8.2), turn off the memory transmis-
sion by simply pressing that key.
NOTE: “Monitor” is assigned to a soft key in F-300 model in the default setting.
4
Dial the fax number.
• Use the numeric keys to dial a number.
–or–
• Press one-touch key. (See page 3.6.)
–or–
• Press
SPEED DIAL
/
GROUP
and three-digit code. (See page 3.8.)
–or–
• Use the phone directory dialing. (See page 3.11.)
NOTE: With real time transmission, only one destination can be dialed.
5
When you hear fax tones from the remote unit, press
START
.
If a person answers the phone, use the handset to tell that person that you are trying
to send a fax. When you hear fax tones, press
START
.
If the call fails and you used “Monitor” to dial, press
ADVANCED FUNCTIONS
repeatedly
until “Monitor” appears, then press
ENTER
or press the soft key to which “Monitor”
is assigned to hang up.
If you are using the handset, hang up after pressing
START
.
NOTE: To cancel a transmission, use Review Commands features. (page 4.8)