Muratec PLAIN-PAPER DIGITAL FAX/COPIER/PRINTER/SCANNER MFX-1330 - Manual (Page 35)

1.17 L
AYOUT
& I
NSTALLATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
L
A
Y
OUT
& I
NST
ALLA
TION
Using the Energy save mode
In order to conserve energy, your machine is initially set to be in the Energy save mode
automatically when the machine is idle for a certain period.
MFX-1330 model automatically enters the Energy save mode in approx. 15 minutes idle
time, and F-300 model does in approx. 5 minutes.
In Energy save mode, the machine stops pre-heating for printing and displays “Energy
Save Mode” on the LCD. However, the LED lamps in the control panel and scanner
lamp will not be off even when the machine is in the Energy save mode.
To recover from Energy save mode, press any key in the control panel.
When your machine receives a fax message during energy save mode, the machine will
wake up automatically.
To change the Energy save mode setting:
1
Press
MENU
, 2, 1, 0, 5,
ENTER
.
Energy Save Mode:On
 /  /Enter
2
Press or to select on or off.
3
Press
ENTER
to save the setting.
4
Press
RESET
to exit and return to the standby mode.
NOTE: The setting specifying the time until the machine enters Energy save mode can
be changed. Refer to “Idle time setting for switching to the Energy save mode” of
“Entering Initial settings” on page 1.14.
NOTE: If you assign “ Energy Saving ” to the soft key, you can switch your machine to the
Energy save mode immediately by pressing the soft key, regardless of the on/off setting
and time setting. For details of the soft key, see page 8.2.