FUJITSU DL3750+/3850+ - Manual (Page 88)

USING SETUP MODE
User's Manual 5-10
PRINTING A LIST OF
SELECTED OPTIONS The LIST function prints a list of all the printer’s currently selected options.
This function is useful for checking the printer settings when you first enter
setup mode or just before you exit. To print a list of options, load continuous
forms paper and then proceed as follows:
1. Enter setup mode.
Place the printer offline. Press the TEAR OFF button and the
ONLINE button simultaneously until the printer beeps. Wait for the
printer to stop printing and check that the following <>
menu is printed:
2. Select the LIST function.
Repeatedly press the LOAD button or the LF/FF button to position the
red cursor under LIST. Next press the TEAR OFF button or the
MENU button to select the LIST function. The printer starts to print a
list of the currently selected options. The preselected factory settings,
also called factory defaults, are shown on the opposite page.
When the printer finishes printing the list of options, it reprints the
<> menu.
NOTE
To remove the printout, turn the platen knob until the paper can
be torn off at the perforation. In setup mode, you cannot use the
printer tear-off feature (TEAR OFF button).
3. Do either of the following:
• Select another function, or
• Exit setup mode, saving any changes you made.
For details about other functions, see the other sections in this chapter.
To exit setup mode and save your changes, make sure that the red
cursor is positioned beneath SAVE & END, then press the MENU
button or the TEAR OFF button.
<>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT