FUJITSU DL3750+/3850+ User Manual

Page 29

SETTING UP

User's Manual

2-9

Quick

Reference

Introduction

Setting Up

aper

Handling

Printing

Setup Mode

7. Align the print head position with the dot mark (green) on the printer

ejection cover.

Dot mark (green)

WARNING

Avoid touching the print head while using or immediately after using the

printer, as doing so may lead to burns. Wait until the print head cools

down before touching it.

8. Thread the ribbon between the print head and the print guide, then

gently press down on the ribbon cartridge against the printer until it

clicks into place.

(Make sure that the ribbon feed knob is facing upward.)

Print guide

Print head

Ribbon

Print guide

Tip of print head

Ribbon cartridge

9. Turn the ribbon feed knob clockwise to take up any ribbon slack.

10. After the ribbon cartridge has been installed in the printer, adjust the

paper thickness lever to match the thickness of the paper and the

number of sheets of paper to be used

For information about the paper thickness lever, see the section

entitled Adjusting the Paper Thickness in Chapter 3.