Using single sheets, Loading a single sheet of paper, Using single sheets –5 – FUJITSU DL3750+/3850+ User Manual

Page 55: Loading a single sheet of paper –5

User's Manual

PAPER HANDLING

3-5

Quick

Reference

Introduc-

tion

Setting Up

Paper

Handling

Printing

Setup Mode

USING SINGLE SHEETS

This section describes how to load paper in the cut sheet stand.

The cut sheet stand allows paper to be loaded manually, one sheet at a time.

Loading a Single Sheet of Paper

To load a sheet of paper into the cut sheet stand:

1. Make sure that the printer is turned on. Check that rear-fed continu-

ous forms are retracted to the park position. (For details, see the

section Unloading Continuous Forms later in this chapter.)

Table 3.2 Paper Thickness Lever Settings

Number of Copies

(Including the Original) *1

1 copy

2 copies

3 copies

4 copies

5 copies

Ribbon replacement

*1 For carbon-interleaved paper, the carbon counts as one copy.

*2 Vary the setting up or down (including A to D) to optimize printing.

Select D when replacing a ribbon or clearing a paper jam. For labels

and envelopes, use trial-and-error to determine a satisfactory setting.

NOTE

If printing is messy, the ribbon misfeeds, or the paper jams, move the

lever one setting higher.

Setting *2