FUJITSU DL3750+/3850+ - Manual (Page 47)

SETTING UP
User's Manual 2-27
Quick
Reference
Introduction
Setting Up
P
aper
Handling
Printing
Setup Mode
4. Use your software printer selection menus or the printer setup mode
(described in Chapter 5) to make required changes in the page layout
or other print features.
If the printer does not print or prints the wrong characters, proceed as
follows:
• Make sure that the interface cable is properly connected.
• Make sure that the printer emulation selected in your software is
the same as that selected on the printer.
• If you are using a serial interface, make sure that the printer
serial interface settings are the same as those on the computer. The
printer’s preselected factory settings are 8 data bits, no parity, 1
stop bit, 9600 baud, and XON/XOFF protocol.
You can change the serial settings on either the printer or your
computer. To change the printer settings, see Chapter 5. To
change the computer settings, use the selection menus provided by
your software or the commands of your computer operating system.
The following example uses the MS-DOS operating system: