FUJITSU DL3750+/3850+ User Manual
Page 46
SETTING UP
2-26
User's Manual
5. Exit MENU1.
Press the ONLINE button to exit the MENU1 function and reprint the
<
6. Exit setup mode to save the emulation.
To exit setup mode and save the new emulation, make sure that the red
cursor is positioned under SAVE & END. Then press the MENU
button. The printer selects SAVE & END and then goes online.
To change other printer settings using the printer setup mode, see Chapter 5.
Once the self-test verifies that the printer is functioning correctly, try printing
using one of your software packages. This exercise will ensure that the printer
is correctly connected to your computer.
If you are using a parallel interface, the printer usually prints the correct
characters automatically. However, you may need to adjust the page layout or
various print features using your software or the printer setup mode. If you are
using a serial interface, the printer may not work at all or it may print a lot of
“?” characters. In this case, the serial settings on the printer do not match
those of your computer or your software. Before changing any settings, use
the procedure described below to try printing using the printer’s preselected
factory settings.
Test communication between the printer and computer as follows:
1. Load a sheet of paper.
2. Check that the printer is online. If the ONLINE indicator is not green,
press the ONLINE button.
3. Try to print using your word processor, a programming language, or
other software.
PRINTING A SAMPLE PAGE
(ONLINE)