FUJITSU DL3750+/3850+ - Manual (Page 131)

Setup Mode
USING SETUP MODE
User's Manual 5-53
Quick
Reference
Introduc-
tion
Setting Up
Paper
Handling
Printing
Setup Mode
Procedure
To print hex dumps, make sure that continuous forms paper is loaded into
the printer. Then proceed as follows:
1. Enter setup mode.
Press the TEAR OFF button and the ONLINE button simultaneously
until the printer beeps. Wait for the printer to stop printing and
check that the following <> menu is printed:
<>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT
2. Select the HEX-DUMP function.
Repeatedly press the LOAD button or the LF/FF button to position
the red cursor under HEX-DUMP, then press the TEAR OFF button
or the MENU button to select the HEX-DUMP function. The printer
goes online and prints a header and a short help menu.
3. Print the hex dump.
To start hex dump printing, send your file or program to the printer.
The printer goes online and prints the hex dump.
Press the MENU button or the TEAR OFF button to pause during
hex dump printing. To resume hex dump printing, press the button
again.
NOTE
When hex dump printing stops, the printer remains online in
setup mode (the ONLINE indicator is green). To print another
hex dump, send another file to the printer.