FUJITSU DL3750+/3850+ - Manual (Page 106)

USING SETUP MODE
User's Manual 5-28
NOTE
Whenever you select a new emulation, all MENU1 or MENU2
options are reset to the factory defaults for that emulation.
4. If necessary, change the other MENU1 or MENU2 options.
Press the LOAD button or the LF/FF button to move the cursor to the
option you want to select. Press the MENU button to select the
option and print the next item listed in Table 5.3. Press the TEAR
OFF button to select the option and print the previous item.
5. Exit MENU1 or MENU2.
Press the ONLINE button to exit the selected function and reprint the
<> menu.
6. Do either of the following:
• Select another function, or
• Exit setup mode, saving your changes.
For details about other functions, see the other sections in this
chapter. To exit setup mode and save your changes, make sure the
red cursor is positioned beneath SAVE & END, and then press the
TEAR OFF button or the MENU button.
Resetting MENU1 and MENU2
To reset the factory defaults for both MENU1 and MENU2, select the
DEFAULT function. For more information, see the section Resetting
Defaults later in this chapter. The DEFAULT function cannot reset those
options which are handled by the HARDWRE, ADJUST, and CONFIG
functions.