FUJITSU DL3750+/3850+ - Manual (Page 62)

PAPER HANDLING
User's Manual 3-12
6. Fit the paper feed holes onto the left and right tractor pins. Adjust the
left tractor (as seen from the rear of the printer) to the width of the
form. Close the paper holders.
7. Pull the left tractor (as seen from the rear) to stretch the paper taut.
Push the left locking lever down to secure the tractor in place.
8. Strongly pull the back cover off of the cut sheet stand (in the
direction indicated by the arrow) and set it down.
Cut sheet stand
Back cover
Setting the back cover
9. Install the cut sheet stand. For installation, see the section Installing
the Cut Sheet Stand in Chapter 2.
10. Press the LOAD button to advance the paper to the top-of-form
position. Top-of-form is the first line on which printing can start.
11. Press the ONLINE button to place the printer online. Print a sample
page and check the page margins. Make the following adjustments,
as necessary:
• Horizontal alignment. Move the forms tractors as required.
• Top-of-form setting (see Chapter 5).
• Margin settings. Use your software or the printer setup mode (see
Chapter 5).
If the paper cut position and the perforation position do not fit, adjust
them by using the following procedure.