FUJITSU DL3750+/3850+ - Manual (Page 129)

Setup Mode
USING SETUP MODE
User's Manual 5-51
Quick
Reference
Introduc-
tion
Setting Up
Paper
Handling
Printing
Setup Mode
Printing the Self-Test
The SELF-TST function prints test pages to check how the printer operates
independently of your computer. The self-test does not check the interface
between the computer and the printer.
The self-test prints the printer’s firmware version, its resident emulations,
and all of the characters available in the currently selected character set. If
the DPL24C PLUS emulation is selected for MENU1, the self-test is printed
using the settings currently assigned to MENU1.
Procedure
This procedure assumes that you are in setup mode. To print the self-test,
make sure that continuous forms paper is loaded into the printer. Then
proceed as follows:
1. Print the <> menu.
The <> menu should be the last printed line on the
page. If the menu is not printed, press the ONLINE button to print
the menu. If you are using the HEX-DUMP function, press the LF/
FF button instead of the ONLINE button to print the menu. The
following <> menu is printed:
<>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT