FUJITSU DL3750+/3850+ User Manual
Page 120
USING SETUP MODE
User's Manual
5-42
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG Items
Options
Description
In some application programs, data
(continued)
transfer may stop temporarily due
to internal processing. This setting can
avoid an undesired tearoff feed by
waiting for up to six seconds each time
data transfer stops.
Single sheet autoloading.
AUTO
Single sheet paper is automatically
loaded a certain time after you set
the paper.
BUTTON
Single sheet paper can be loaded by
pressing the LOAD button.
The following
specified for the
Autoload start time.
0.5, 1.0,
Autoloading starts when this
1.5, 2.0
amount of time passes after you set
2.5, 3.0SEC
single sheet paper.
Command decode timing.
DIRECT
The printer decodes certain commands
immediately after receiving data.
Example:
ESC SUB I, ESC CR P (DPL24C+)
ESC Q # (IBM XL24E)
QUEUED
The printer decodes commands after
storing all data (including commands)
in the input buffer. This speeds data
reception because the printer does not
require decoding time during data
reception.