FUJITSU DL3750+/3850+ - Manual (Page 119)

Setup Mode
USING SETUP MODE
User's Manual 5-41
Quick
Reference
Introduc-
tion
Setting Up
Paper
Handling
Printing
Setup Mode
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
Tearoff position.
VISIBLE Select this option when your software
positions forms to the next top-of-form
after printing the last data. The printer
performs tearoff feed without adding a
form feed when data transfer has
stopped.
ALWAYS Select this option when your software
stops after printing the last data. The
printer performs tearoff feed after
adding a form feed when data transfer
has stopped.
Note: For both settings, tearoff
positioning will fail if the page length
setting does not match the actual
perforation spacing.
The following item is printed when TEAROFF:AUTO is
specified for the item.
Tearoff enabled time (offset time).
0 SEC The offset time is from when data
1 SEC transfer stops to when the printer
2 SEC performs automatic tearoff feed.
4 SEC If the printer receives data again
6 SEC within the offset time, the printer does
not perform automatic tearoff feed.
CONFIG Items Options Description