Arturia KeyStep Pro Keyboard with Advanced Sequencer and Arpeggiator - Manual (Page 167)

9.5.2. Sync
These settings allow you to specify the inputs for receiving synchronization and tempo
signals, as well as the input and output clock rates. By changing these settings, you
determine which type of clocking signal will be transmitted via the output connectors and
which type will be recognized by the sync/clock inputs.
9.5.3. Metronome
To activate the Metronome, hold down 'Shift' and press Tap Tempo/Metronome. The default
time signature is 4/4. To set the time signature to - for example - 5/8, set Time Division to 8
and Time Signature to 5.
The options in this menu enable you to change the default Metronome settings:
• Count in: set count-in length (off, 1 bar (d), 2 bars)
• Time-division (1/4 note (d), 1/4 note triplet, 1/8 note, 1/8 note triplet, 1/16 note, 1/16
note triplet, 1/32 note, 1/32 note triplet)
• Time Signature (1-16), default= 4
9.5.4. Launch Quantize
In this menu, you 'tell' the KeyStep Pro how it should continue to the next Pattern, Chain
or Scene. Should it wait for 1 bar, 2 bars or 4 bar to make the switch? This is useful in live
performance settings where you may not want to interrupt the flow of the music between
Projects.
If the Sequencer and Drum Patterns are of unequal length, the KeyStep Pro will wait until
the end of the Drum Pattern before loading the next Project Scene or Pattern.
Arturia - User Manual Keystep Pro - KeyStep Pro Configuration 161