Shafl – Generac Power Systems MC User Manual

Page 74

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

3.3.1.17-Remove governor

shafL

retaining clip and governor

shaft.

3.3.1.19-Remove bolts that ret

ain counterbalance cover.

3.3.1.21-Remove

counterbalance

assembly.

3.3.1.18-Remove oil stopper from

engine bearing cover.

3.3.1.20-InstaII a bolt into the

threaded hole at top of counter

balance cover. Tighten bolt aga

inst counterbalance shaft until

cover is free of shaft, then i*e-

move cover.

3.3.1.22-$him washers are used at

bearing cover end of crankshaft

to establish crankshaft end play.

Check uumber of shims- during re

assembly, the same number of shims

must he used.

3.3-A