Generac Power Systems MC - Manual (Page 4)

SECTION 1.1
SPECIFICATIONS
1.1.T-M0DEL NUMBERS
Model No,
MC-35
6894
MC-35
6895
MC-38
6938
MC-38
69 39
MC-40
6896
MC-40
6897 ..
Wattage Capacitv 3500 3500 3800 3800 4000 4000
Voltage 120* 120* 120* 120* 120* 120*
Maximum Amperes 29,2 at 120 V, 31,7 at 120 V. 33.3 at 120 V.
Phase 1-Phase 1 1-Phase 1-Phase 1-Phase 1 -Phasel_1-Phase
Frequency 60 Hertz at 3600 rpm
Voltage
Regulation Solid state voltage regulator maintains 120 Volts AC
(±27o) at 60 Hertz
Batterv Charge 0-10 Amperes at 12 Volts DC
Gross Weight
(wet)
Approximately 127 pounds
Engine Part No, 48078 48078 48078 48078 48078 48078
Bore 78 mm
Stroke 62 mm
Displacement 296 cc
Governed Speed 3720 rpm at no-load
Ignition System Solid State
Starting System 12 Volt DC electric (Ring Gear)
Cranking Current Approximately 90 Amperes
Average Fuel
Consumption
Approximately 0,70 Gallons per Hour
Type of Fuel
Pump
Mech, Elec, Mech, Elec, Mech, ■ Elec,
'Factory connected for 120 Volt AC output only. Unit is reconnectable
to provide dual voltage output.
1.1.2-FUELS AND OILS
RECOMMENDED FUEL
Use NON-LEADED gasoline. Leaded REGULAR grade gasoline is an acceptab­
le substitute. Do not use any highly leaded, premium gasoline,
RECOMMENDED OIL
Use oil classified ”For Service SC,
SD or SE”, as shown in the CHART at
right.
I---------------------------------------^-----------------------------
USE OIL CLASSIFIED "FOR SERVICE SC, SD, or SE"
USE SAE 10 W
Of
10W-30OIL
USE SAE 20 W
or 10W-30 OIL
USE SAE 30 OIL
-10“F. 10“F. 32'F.
■22^C.
•12.2'^C. O'C.
TEMFERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
1
,
1-1