Generac Power Systems MC User Manual
Page 73
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3,3,l.l2-RGmovc governor slider from 3.3.1.13-Remove cam shaft and valve
end of cam shaft.
tappets*
3* 3*1*14-Bend lock Cab ends away from
connecting rod bolt heads. Remove the
connecting rod bolts, lock tab, oil
splasher and connecting rod lower half.
Push piston and connecting rod up
through cylinder and remove. Remove
crankshaft.
3.3.1.16-It is not necessary to
remove bearings unless replace-
menc is necessary. Bearings
must be pressed out of cylinder
block.
3.3.1.15-Remove oil stopper,
3.3-3