Generac Power Systems MC User Manual

Page 60

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SECTION 3.2

ALTERNATOR SECTION

3.2.1-DISASSEMBLY

3#2»1«1-At the terminal strip, dis

connect Che Wire No. 20 chat comes

Truiu the low oil level shutdown sw

itch.

3.2.1.3“Remove 4 screws that retain

irront panel. Remove front panel.

3.2.1.5-Remove screws that retain

rear panel. Remove rear panel.

3.2.1.2“Loo3en oil line clamp at

oil make-up pump. Slide clamp down

hose, then disconnect hose from

pump fitting.

3,2,1.6-Unplug the red connector

plug from Its stator can recepLacle,

Also remove ground wire, retained

by panel divider screw.

3.2.1.6-Remove end panel.

3.2-1