Generac Power Systems MC User Manual

Page 61

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

3.2,1,7~St:raighCpn brush holdei'

locking tangs on bearing carrier,

Kemove brush holder from carrier.

Remove brush leads from brushes

and remove brush holder and brus

hes .

3,2,1»d-Remove al temator support

to vibration dampener bolts.

3,2.1,9-Remove two bottom stator 3,2.1,10-Remove 6 screws that ret-

bolts and stator bolt bar.

aln bearing carrier to stator can,

Remove bearing carrier, using a

puller.

3,2,1.11-Ramove 2 upper stator

bolts and stator holt bar.

3,2.1.12-RGmove panel divider. The

stator can may now be removed as

well.

3.2-2