Generac Power Systems MC User Manual
Page 69
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3.2.3.20-Connecc 2 red wires (No. 3,2.3.21-Sllde brush holder lock-
A) to brush that will he nearest
Che rotor bearing. Retain \^th a
No, 6-32 Sims screw and 2 exter
nal lockwashero. Connect 2 ground
wires (No. 10) to remaining brush
with Sims screw and 2 lockwashers
3.2.3.22-Retaln brush ground wire
(No. 10) to heat sink with heat
sink retaining screw.
ing grooves over bearing carrier
locking tangs. Make sure brushes
contact slip rings properly. Bend
bearing carrier locking tangs to
retain brush holder.
3.2.3.23-Install end panel. Ret
ain to stator can with two No. 10-
32 X 3/R” Taptite screws. (A small
grounding lug is also retained by
one of these screws.)
3.2-10