Interlogix TruVision Navigator 5.0 User Manual - Manual (Page 167)

Appendix A: Device Details
TruVision Navigator 5.0 Service Pack 3 User Manual 159
Feature Support Notes
IP Cameras UTC Legend – Firmware:
Legend (NTSC or PAL) 3.77
UTC CamPlus – Firmware:
UTCC-IPDRH-DN-POE-P A1D-M2N-
V2.07.04-NB
UTCC-IPDRH-DN-POE A1D-M2N-
V2.07.04-NB
UTC CamPlus2 – Firmware:
UTCC-IP2VD-DN V1.00E3
UTCC-IP2VD-DNP V1.00E3
UTCC-IP2D V1.00E2
UTCC-IP2D-P V1.00E2
UTCC-IP2B V1.00E2
UTCC-IP2B-P V1.00E2
UTC UltraView – Firmware:
UVC-IP-EVRDN-HR 4.2.1, 53820
UVD-IP-EVRDNR 4.2.1, 53820
UVC-IP-EVRDN-HR-P 4.2.1, 53820
UVD-IP-EVRDNR-P 4.2.1, 53820
UVC-IP-XP3DN-HR 4.2.1, 53820
UVD-IP-XP3DNR 4.2.1, 53820
UVC-IP-XP3DN-HR-P 4.2.1, 53820
UVD-IP-XP3DNR-P 4.2.1, 53820
UTC UltraView Encoder – Firmware:
UVE-101/DC105 (NTSC) 4.2.1, 53820
UVE-101/DC105 (PAL) 4.2.1, 53820
Axis IP Camera – Firmware:
216MFD 4.47
216MFD-V 4.47
211M 4.41.1
Panasonic I-Pro Network Cameras –
Firmware:
NW484S 1.50E2
NF284 1.50E2
NP-244 1.80E4
UTC Legend IP camera (NTSC) now
available with 7.5 frame rate in both FULL
and CIF.
When the UltraView IP Camera is rebooted,
the camera Date/Time will be set to January
1st, 2003 and will require approximately 5
minutes to re-sync with NTP server. Within
that 5 minutes time period, Instant replay is
not available and will show the “No folder”
image. Note: If the camera cannot sync with
an NTP server than the Date/Time will remain
at January 1st, 2003 until a proper NTP
server is available.
It is not recommended to have the same IP
Camera associated with multiple TVN40s.
The stream will flicker between the video and
the no video icon in TruVision Navigator.
The only frame rates supported for IP
Cameras are those in the TruVision
Navigator drop-down menus.