Interlogix TruVision Navigator 5.0 User Manual - Manual (Page 157)

Appendix A: Device Details
TruVision Navigator 5.0 Service Pack 3 User Manual 149
Feature Support Notes
Bulk Configuration Yes
Remote Reboot Yes
IP Cameras UTC CamPlus2 IP Models -
Firmware:
UTCC-IP2VD-DN - V1.00E3
UTCC-IP2VD-DNP - V1.00E3
UTCC-IP2D - V1.00E2
UTCC-IP2D-P - V1.00E2)
UTCC-IP2B - V1.00E2)
UTCC-IP2B-P - V1.00E2)
UTC UltraView IP - Firmware:
UVC-IP-EVRDN-HR - 4.2.1, 53820
UVD-IP-EVRDNR - 4.2.1, 53820
UVC-IP-EVRDN-HR-P - 4.2.1,
53820
UVD-IP-EVRDNR-P - 4.2.1, 53820
UVC-IP-XP3DN-HR - 4.2.1, 53820
UVD-IP-XP3DNR - 4.2.1, 53820
UVC-IP-XP3DN-HR-P - 4.2.1,
53820
UVD-IP-XP3DNR-P - 4.2.1, 53820
UTC UltraView Encoder - Firmware:
UVE-101/DC105 (NTSC) - 4.2.1,
53820
UVE-101/DC105 (PAL) - 4.2.1,
53820
UTC TruVision H.264
Models TBD
Panasonic I-Pro Network Cameras -
Firmware:
NW484S - 1.50E2
NF284 - 1.50E2
NP-244 - 1.80E4
Adding the UltraView IP or Encoder to the device
via TruVision Navigator can take 10-20 seconds.
The UltraView IP or Encoder can take 10-20
seconds to stream video once its configuration has
been changed.
Motion JPEG is not supported on the CamPlus2.
If IP cameras are added through the device’s OSD
or Web Browser, they MUST be added in
sequential order in the 16 available slots on the
device (i.e. 1, 2, 3, and 4).
The device supports up to 8 IP cameras.
For the TruVision H.264 IP Camera, turn off
Display Name and Display OSD via the camera’s
Web Browser or you will see duplicate time/date
stamps overlaid on the video – 1 from the camera
and 1 from TruVision Navigator.