Interlogix TruVision Navigator 5.0 User Manual - Manual (Page 161)

Appendix A: Device Details
TruVision Navigator 5.0 Service Pack 3 User Manual 153
Feature Support Notes
Notifications Alarm
Video Loss
Motion
Disk Full
Disk Failure
To setup the device to send TCP notifications for
cameras, right-click on the device in the Navigator
and select Configure Device. On the Camera
Tab’s Event Section, select the events you would
like to receive and set the schedules as
appropriate. On the Camera Tab’s Rules Section,
for each event type, ensure that “notify me” is
selected. Repeat for each event type. On the
Notifications Tab, the Notify IP Address should be
the IP address of where the TruVision Navigator
Server services are located (Notification Writer and
Notification Processor). The Notify Port is
defaulted to 5001 and is editable. Ensure this port
matches the one listed on the TruVision Navigator
Server Properties dialog, Notifications Tab.
To setup the device to send TCP notifications for
the device itself (i.e. Disk Full and Disk Failure),
right-click on the device in the Navigator and select
Configure Device. On the Notification Tab, for
each notification type, ensure that “notify me” is
selected. Repeat for each notification type and
click Save. Ensure the notification port on the
device matches that of TruVision Navigator Server
as described above.
Restart both the Notification Writer and Notification
Processor for TruVision Navigator to process the
notifications.
Health Diagnostics IP Address
MAC Address
Model Name
Serial Number
Firmware Version
Device Date/Time
Total Device Health
HDD Status
HDD Capacity
Cameras in Video Loss
Cameras in Alarm
Current Client Connections
Record Status
Firmware Upload Yes
Bulk Firmware
Upload Yes
Device
Configuration Yes For TVN21 and TVN50, Synchronize IP Camera
option should be enabled to have camera
parameters applied completely.