Interlogix TruVision Navigator 5.0 User Manual - Manual (Page 145)

Appendix A: Device Details
TruVision Navigator 5.0 Service Pack 3 User Manual 137
Feature Support Notes
Notifications Alarm
Video Loss
Motion
Disk Full
Disk Failure
To setup the device to send TCP notifications for
cameras, right-click on the device in the Navigator
and select Configure Device. On the Camera Tab’s
Event Section, select the events you would like to
receive and set the schedules as appropriate. On
the Camera Tab’s Rules Section, for each event
type, ensure that “notify me” is selected. Repeat for
each event type. On the Notifications Tab, the Notify
IP Address should be the IP address of where the
TruVision Navigator Server services are located
(Notification Writer and Notification Processor). The
Notify Port is defaulted to 5001 and is editable.
Ensure this port matches the one listed on the
TruVision Navigator Server Properties dialog,
Notifications Tab.
To setup the device to send TCP notifications for the
device itself (i.e. Disk Full and Disk Failure), right-
click on the device in the Navigator and select
Configure Device. On the Notification Tab, for each
notification type, ensure that “notify me” is selected.
Repeat for each notification type and click Save.
Ensure the notification port on the device matches
that of TruVision Navigator Server as described
above.
Restart both the Notification Writer and Notification
Processor for TruVision Navigator to process the
notifications.
Health
Diagnostics IP Address
MAC Address
Model Name
Serial Number
Firmware Version
Device Date/Time
Total Device Health
HDD Status
HDD Capacity
Cameras in Video Loss
Cameras in Alarm
Current Client Connections
Record Status
Firmware
Upload Yes
Bulk Firmware
Upload Yes
Device
Configuration Yes