Setting frequency jumpers on the senrx module, Setting frequency jumpers on the genii wmi, E 4-10 – Innotech Genesis II Digital Controller (v5) User Manual
Page 95
Page 95
Genesis II Installation Instructions
© Mass Electronics Pty Ltd 2010
Chapter 4 – Commissioning
4-1.4.4 Frequency Jumpers
The GENII WMI Wireless Module Interface provides an interface to the SENRx series of wireless
temperature sensors. There are four user selectable frequency jumpers for configuration. To enable
correct communication over a wireless frequency, the settings of these jumpers must be matched.
Locations and settings of frequency jumpers a fare shown on the datasheets for each of these
products. Figure 4-9 shows a portion of a the GENII WMI datasheet, and Figure 4-10 shows an image
of the SENRx series of wireless temperature sensors.
Frequency jumper connectors are F0, F1, F2 and F3. Frequency jumpers must be set properly on all
wireless REMs.
Figure 4-9: Setting Frequency Jumpers on the GENII WMI
Figure 4-10: Setting Frequency Jumpers on the SENRx Module