Fit eol jumper fit eol jumper – Innotech Genesis II Digital Controller (v5) User Manual
Page 109
Page 109
Genesis II Installation Instructions
© Mass Electronics Pty Ltd 2010
Chapter 5 – Network Installation
Fit EOL
Jumper
Fit EOL
Jumper
Port 1
Fit EOL
Jumper
Port 2
Fit EOL
Jumper
Fit EOL
Jumper
Fit EOL
Jumper
Example Figure 5-6:
This example shows a Genesis II Direct Digital Controller with a network of REMs and an Innotech
Repeater IR11 fitted. Once a Repeater is installed there are effectively two individual networks and
each must have their EOL jumpers fitted as required, as illustrated at Example 1 in
Example Figure 5-7:
This example shows a Genesis II Direct Digital Controller with a network of REMs. In this example, the
digital controller is in the middle of the run.
Both ends must have EOL jumpers fitted.
NOTE
Both ends must have EOL jumpers fitted.
NOTE
Figure 5-6: Example of REM Network with an Innotech Repeater IR11
Figure 5-7: REM Network with Digital Controller in the middle of a run