Innotech Genesis II Digital Controller (v5) - Manual (Page 28)

Genesis II Installation Instructions
Page 28 © Mass Electronics Pty Ltd 2010 Edition 2.0 dated 06/12/2013
Side View
Top View
90 Degrees
45
Degrees
2-3.2 General Installation Instructions
To ensure continued reliable operation of the Genesis II System, the following installation guidelines
should be observed:
• The Genesis II Direct Digital Controller or MPCII Mid Points Controller should be installed in a
position that provides easy access to the front panel and sufficient room for power, and input/
output cabling. Also, the Digital Controller should be mounted such that the controls are in easy
reach of the user. This requirement does not apply to the MPCII Mid Points Controller which has no
external controls or indicators.
• Placement of the Genesis II Direct Digital Controller should take into account the optimum
viewing angle of the Liquid Crystal Display (LCD), which is approximately 45° vertically and 90°
horizontally (see Figure 2-12).
• Do not mount any unit of the system near high voltage, high current cables or sources of strong
radio frequency emissions such as transmitter antenna cables.
• The ambient temperature of the digital controller and REMs at the installation site should not
exceed the 0-40 °C temperature range.
• Mount the units in an area with minimum vibration and minimum exposure to mechanical
damage.
• The REMs must be installed within 600 metres of the Genesis II Direct Digital Controller or MPCII
Mid Points Controller.
Figure 2-12: Genesis II DDC Optimum Display Viewing Angle