Genii ai rem analogue input module – Innotech Genesis II Digital Controller (v5) User Manual
Page 20

Genesis II Installation Instructions
Page 20
© Mass Electronics Pty Ltd 2010
Edition 2.0 dated 06/12/2013
2-2.2.1 REM I/O Expansion Modules
REM I/O Expansion Modules increase the Input and/or Output capabilities of a Genesis II Series digital
controller.
There are a total of six different REM I/O Expansion Modules.
• GENII AI REM Analogue Input Module
• GENII AO REM Analogue Out Module
• GENII DI REM Dry Contact Digital Input Module
• GENII DO REM Relay Output Module
• GENII IDI REM Opto Isolated Digital Input Module
• GENII PI REM Pulse Input Module
Common Enclosure Information
The above listed REM I/O Expansion Modules are housed in a rectangular case made from flame
retardant polycarbonate / ABS plastic listed under UL94. (
GENII AO REM is listed under UL94-VO)
Colour:
Grey
Dimensions (max):
75mm(w) x 155mm(h) x 57mm(d)
Mounting:
DIN Rail Mounted
The cable run between the digital controller and the REM I/O Expansion Modules should not exceed
600 metres. However, the maximum cable length can be increased through the use of Innotech
Repeater IR11 module. (See
for more information)
Below is a schematic of the GENII AI REM Analogue Input Module. The above listed REM I/O Expansion
Modules feature the same dimensions and similar appearance. Refer to Figure 2-4.
75
57
155
GENESI S
ANALOG INPUT
Re mote Expansio n M odul e
1 2 3
TX
RX
A
C
B
D
F
E
G H I J
L
K
SCREEN
SCREEN
+A1- +A2- +A3- +A4- +A5- +A6-
Figure 2-4: GenII AI REM Analogue Input Module