Innotech Genesis II Digital Controller (v5) - Manual (Page 9)

Page 9 © Mass Electronics Pty Ltd 2010 Edition 2.0 dated 06/12/2013
SENRx Wireless Temperature Sensor (Back View) .................................................73
Checking Power Input .............................................................................................79
Checking Digital Input Wiring .................................................................................81
Checking Dry Contact Inputs ..................................................................................83
Checking Digital Output Wiring ..............................................................................85
Analogue Input Signal Conditioner (AISC) Locations ............................................87
Address Jumpers, Typical Settings ........................................................................92
End of Jumper, Typical Location ............................................................................93
Setting Analogue Output Jumpers.........................................................................94
Setting Frequency Jumpers on the GENII WMI ......................................................95
Setting Frequency Jumpers on the SENRx Module ...............................................95
Correct and Incorrect Bus Topology.....................................................................105
Adding Modules to a Network ..............................................................................106
Linking Networks in Different Locations ..............................................................107
Multi-Network Arrangement .................................................................................108
Example of a Simple REM Network ......................................................................108
Example of REM Network with an Innotech Repeater IR11 ................................109
REM Network with Digital Controller in the middle of a run ...............................109
REM Network with Innotech Repeater IR11 in the middle of a run ....................110
Use of Repeaters to expand the Primary Network ..............................................111
Example of Comms Screen Connection ...............................................................112
Typical Comms Network Connections .................................................................112
Innotech Repeater IR11 and IR12 .........................................................................114
Networking and Earthing the Innotech Repeater IR12 .......................................115
GENII MPI Modem and Printer Interface ..............................................................116
Hazardous Connection Example, Circuit 1 ..........................................................117
Hazardous Connection Example, Circuit 2 ..........................................................118
Use of GENII MPI, Circuit 1 ....................................................................................119
Use of GenII MPI, Circuit 2 .....................................................................................120
Voltage Check, Isolated/Non-Isolated Digital Controller ....................................122
Voltage Check, GENII MPI with Isolated/Non-Isolated RS485 .............................122
Voltage Check, Innotech Repeater .......................................................................123 Figure 3-23:
Figure 4-1:
Figure 4-2:
Figure 4-3:
Figure 4-4:
Figure 4-5:
Figure 4-6:
Figure 4-7:
Figure 4-8:
Figure 4-9:
Figure 4-10:
Figure 5-1:
Figure 5-2:
Figure 5-3:
Figure 5-4:
Figure 5-5:
Figure 5-6:
Figure 5-7:
Figure 5-8:
Figure 5-9:
Figure 5-10:
Figure 5-11:
Figure 5-12:
Figure 5-13:
Figure 5-14:
Figure 5-15:
Figure 5-16:
Figure 5-17:
Figure 5-18:
Figure 5-19:
Figure 5-20:
Figure 5-21:
List of Illustrations (Continued)